Fun Factory Bi Stronic Fusion: Charging, Travel Lock and Reviving a Flat Toy

The Bi Stronic Fusion and similar dual-motor Fun Factory toys charge the same way as the rest of the range, using the Click 'n Charge magnetic USB cable. Where they differ is the travel lock, which can catch out new owners if a fully charged toy suddenly won't turn on.

Charging

• Line up the magnetic charger with the charging point on the toy. It should click into place.
• The indicator light blinks while charging is in progress.
• A constant, solid light means the toy is fully charged.

Toy Won't Turn On After Charging

If the toy is fully charged but won't turn on, it's most likely travel locked rather than faulty.

• Hold down the FUN button and the button with the larger dot (the shaft control button) together for a few seconds. The toy should buzz briefly to confirm the travel lock has been released, and can then be turned on as normal.
• Alternatively, holding the power button alone for at least 3 seconds should turn the toy on if travel lock is not active.

Reviving an Extremely Flat Toy

If the toy has been left uncharged for a long time and won't respond at all when plugged in:

• Connect it to the Click 'n Charge cable and leave it on charge for longer than usual, such as several hours, before checking again. Deeply discharged batteries can sometimes take longer than normal to register as charging.
• Check the indicator light periodically rather than assuming no light means no charge is happening. Some units take a while to show a blinking light after being very flat.
• Use the original or an official Fun Factory charging cable rather than a third-party magnetic cable.
• Avoid leaving it on charge unattended for excessive periods once it does start charging normally.
• If there's still no response after an extended charge, this points to a battery or hardware fault, and is worth reaching out to us about for warranty support.